How to Install Cabel LAN / UTP RJ45

This tutorial is suitable for a beginner / learning is still in the build your own network at home or school, especially of more than 2 client, using the hub (much cheaper rather than the router), especially now with the property of Telkom Speedy using Lan cable.

UTP, short for "Unshielded Twisted Pair." Unshielded called because it is less resistant to interference elektromagnetik. And called Pair twisted pair in the cable there is a spiral, or structured mutual berlilitan having cable 8. There are category 5 UTP cable, from category 1 to category 5 For a computer network is a popular category 3 and category 5.

Any equipment required for installing the cable Lan / network

1. UTP cable is the usual standard in the use balden brand.

2. Head Conector or commonly called us the same as RJ45 form conector telepone but quite large.

3. Crimping pliers or special tools. This tool functions to turn off or to press the RJ45 cable to UTP. So if one is in the crip, the RJ 45 itusudah can not be removed the plug again. So you should consider before you order the cable Crimp.

4. LAN Tester - lan tester function is to see the order of the cable before you make are correct or not. Straight to the type if the order is then led all of a 1 - 8 will turn up.

If all the equipment is all ready, we started only the first step peeled protective UTP cable approximately 2 cm or approximately just enough so that the entrance to the RJ-45. Then trim the edges so that does not fall apart ago Sort according to the type you'd like to make straight and cross type. For that you can see the sequence below:

Straight type:

This sequence is easily the most important between the end of the one with the other must be the same (self).

the default colors are as follows:

1. White Orange

2. Orange

3. White Green

4. Blue

5. White blue

6. Green

7. White chocolate

8. chocolate

So you live alone identify only the tip of the persih with the above. So essentially the end of the one with the exact same one.

Type Cross / Cross:

Cross cable used to connect a normal PC's to PC / PC to Router, The connection of all equipment that is usually a connection through the switch or hub, but is installed directly. Here is an example in the position of the cable crossover. This model is only the tip of the cross between the one with the other.

Sequence as follows:

1. White Orange

2. Orange

3. White Green

4. Blue

5. White Blue

6. Green

7. White Brown

8. Brown

Edge that one:

1. White Green

2. Green

3. White Orange

4. Blue

5. White Blue

6. Orange

7. White Brown

8. Brown