Tutorial : How to Install Network (Lan)

Computer Networking is connecting two or more computers, so that between one computer to another can exchange resources such as sharing files, printers, etc. by using the protocol the same, in this case the TCP / IP. The computer network has been used for many different needs, Suppose :

- WARNET
- Multiplayer GAME
- Office
- Campus, Etc

To create a network computer device is required as follows :

- Two or more computer
- LAN Card / NIC in accordance with the number of computer (for the computer is now usually have onboard Lan Card)
- UTP cable according to the needs of
- Crimping Tools or special pieces for Tang Lan
- RJ45 connector
- Switch / Hub if you want to use the three computer Or u more
- Scissors

After all the equipment we have collected more ready to make a network computer, the steps are as follows :

Specify MAU HOW TO MAKE A NETWORK COMPUTER ?

This is necessary because the configuration for the cable network two to three computer / more different.
To connect the two computers are not needed and use the switch with UTP cable pengkabelan types of straight, while for networks with three or more computer using UTP cable and switch configuration with a cross over.

INSTALLING TO RJ-45 UTP KABEL

Because in this tutorial we will use the UTP cable as a medium, then we must have an RJ-45 connectors on the cable is to be on the LAN CARD ditancapkan, as has been said before two-computer network configuration with three different computer, do the following :

Two-computer configuration using the crossover

1. Peeled the second end of the epidermis using UTP cable Crimping blade or scissors, with a length of approximately 1.5cm.

Download for more clearly in the version of Acrobat Reader (Pdf)